Material difference of common metal prototypes for electroforming

      How to use the automatic edge banding machine correctly:
      The correct steps of edge sealing are summarized by many experienced carpenters, which has high reference value. If the automatic edge banding machine encounters difficulties in the actual edge banding operation, its operation details can be selected. Step 1: Select the edge sealant according to the workpiece to be processed and its edge sealing requirements. The furniture edge sealing glue can meet the requirements of edge sealing operation and has strong performance, which can lay a good foundation for high-quality woodworking edge sealing effect. The second step is to raise the temperature of the rubber wheel on the edge sealing machine to 180 degrees until the corresponding signal indicator lights up. Just press another start button to ensure that the air compressor pressure is above the standard value of 0.65 PASCAL. The third step is to control the temperature of the glue solution between 160 ° C and 2 ° C in the melting stage of the sealing edge glue. The temperature of glue shaft and sealing machine should be between 180 ° and 220 °. The fourth step is to install the base materials of the automatic edge banding machine, including edge sealing strips and plates. Among them, the workpiece must rely on the guide rail baffle to make the edge of the plate parallel and uniform in advance. Step 5. Quality inspection is very important, so it is very important to conduct quality inspection before sealing the edges of each sheet of paper. Step 6: Poor edge sealing environment will affect the effect of woodworking edges. As the material of the receiving personnel, it should be cleaned before the dust or sundries accumulate on the surface of the plate to lay a good foundation for the plate edge Z. Step 7: Before or after each edge sealing operation, be sure to clean the sawdust and glue residue on the edge sealing machine. If the edge banding machine is not started for a long time, cut off its power supply. In the sealing machine during drying, the temperature in the plastic tank should be reduced to 120 ℃ to 150 ℃. The establishment of sealing side step is not a stubborn woodworking work. If you want to say a few higher levels, it is a standard. The woodworking edge bonding procedure does not work. In order to maintain the edge bonding quality, the operator of the automatic edge bonding machine is obliged to adhere to this step forever.